Bukarest

STACK locker x2 is outfitted with various storage features. In the upper left section, it contains two thread pull-outs, accommodating thread spools with dimensions of up to 146mm in height and 79mm in diameter. The container includes approximately 520 holes, paired with 260 wooden pegs. Below this, there is a partially extendable shelf designed to hold a machine with a maximum length of 460mm, width between 350mm and 385mm, and height of 367mm. On the right side, you'll find six removable drawers. Three of these drawers have adjustable dividers, allowing for the creation of up to 12 small compartments to organize your accessories. Each drawer measures 275mm in internal width and 430mm in internal depth. The top drawer has a height of 89mm, while the remaining drawers each have a height of 75mm.

STACK layer x2, the spacious accessory container, offers ample storage to kickstart your hobby. This container features two adjustable shelves secured by safety clips and can also be stacked as part of the STACK wall unit. Within the one of the STACK layer cabinets, we incorporate a pull-out and swiveling ironing board into this container on the second level. This ironing board is attached to an extra shelf and can be positioned at your preferred height using the 16mm hole set. Additionally, you can place the included loose iron support rods on the shelf that best suits your needs.

STACK viera-XL x2 offers ample storage space for your hobby needs. The top section of the container includes two thread partial extensions. One can be used internally for thread spools up to 70mm in height, while the other can be used externally for spools up to 75mm in height.

Below this are three drawers on partial extensions. Each drawer has an internal width of 654mm, a depth of 435mm, and a maximum height of 130mm. The bottom drawer, however, has a height of only 115mm.

Viera XL Options:
The 3 drawers can also be individually fitted with a perforated plate (32mm grid) with 500 holes and 250 wooden pins for an additional charge. There is also the option of a plug-in partition for the drawers, which can be plugged into the perforated plate. This consists of 5 longitudinal and 6 transverse subdivisions. If you wish, you can have all pull-outs and drawers equipped with a very stable full extension system.